How to see the performance of laser marking machine is stable and unstable




The performance of the laser marking machine is stable and unstable, which is a factor that everyone will consider when choosing a laser marking machine. The performance stability of the laser marking machine is very important and affects the continuity of industrial production. Even a laser marking machine with very good quality will be unstable. At this time, the marking efficiency of the equipment during operation will be greatly reduced, which is very unfavorable for manufacturing activities. So, how do you think the performance of the laser marking machine is stable and unstable? The following editor summarizes these points for everyone.

The performance stability of the laser marking machine is affected by various factors. Generally speaking, the more expensive the laser marking machine is more secure in terms of performance stability. The performance stability of laser marking machine can be seen from these four factors:

1. The level of craftsmanship. The level of craftsmanship has an impact on all aspects of the laser marking machine, especially for the installation of beam expanders, galvanometers, and marking needles. If the installation position is not adjusted properly, it will lead to deviations in the marking position and affect the laser spot pattern. .

2. Environment. The ambient temperature has an important influence on the operation of the laser marking machine. Too high or too low ambient temperature may cause unstable cooling capacity. At this time, the marking effect will be unstable, and the laser marking machine needs to be cooled or cooled externally. Keep warm.

3. The focal length is not accurate. The focal length of the laser marking machine will also cause the performance of the laser marking machine to be unstable. At this time, it is necessary to adjust the focal length.

4. The lens has abrasion and dust. The laser beam of the laser marking machine is used to engrave and mark on the material through the lens. Once the lens is worn and dusted, the laser beam is prone to deviation, resulting in poor marking effect. At this time, it is necessary to clean the lens. After the lens is cleaned, the effect is still not achieved, and the lens must be replaced.

Through the above introduction, I believe everyone already knows that the performance stability of the laser marking machine can be seen from these factors: environment, process level, focal length, and lens. If you have any questions about the laser marking machine
Navigation